Candy CDI 2212 Mode D'emploi page 47

PROGRAMME SELECTION
AND SPECIAL FUNCTIONS
(Use in conjunction with programme guide)
Programme settings
s Open the door and place the dirty dishes
inside the appliance.
s Press the "ON/OFF" button
All the programme indicator lights will
flash.
s If you wish to select an option, press the
option button (the corresponding indicator
light will light up).
The option button can be selected or
deselected WITHIN one minute of the
programme commencing.
s Choose a programme by pressing the
corresponding button.
s Close the door (after an audible signal
has sounded, the programme will start
automatically).
WITHIN one minute of the programme
commencing, another programme
can be selected, simply by pressing
the corresponding button.
IMPORTANT
To select the "COLD RINSE" programme,
simultaneously press the "RAPID"
programme button and "HPS" option
button.
"IMPULSE" programmes
The "IMPULSE" programmes use an
impluse washing technology, which reduces
consumption, noise
performances.
IMPORTANT
The "intermittent" working of the
washing pump MUST
considered a malfunction, it is a
characteristic of the impulse washing
so must be considered a normal
function of the programme.
.
and increases
NOT BE
47
Programme interruption
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes) the machine stops
automatically. Close the door, without
pressing any buttons. The cycle will start
from where it left off.
WARNING!
If you open the door during the
drying cycle, an audible audio signal
advises you that the drying cycle has
not yet finished.
Changing a running programme
Proceed as follows to change or cancel a
running program:
s Open the door.
s Hold down the current programme button
(with the indicator light on) for at least 5
seconds. The programme indicator lights
will turn on and off individually and
sequentially and some audible signals
will sound.
s The running programme will be cancelled and
all the programme indicator lights will flash.
s At this point a new programme can be set.
IMPORTANT
To cancel the "COLD
programme, simultaneously
down the "RAPID" programme button
and "HPS" option button.
WARNING!
Before starting a new programme,
you should check that there is still
detergent in the dispenser.
If necessary, top up the dispenser.
RINSE"
hold