Publicité
BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
4-5-minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Set to Off (O)
Continuous operation beyond
4-5-minutes will trigger
20-minute cool down period.
ADVANCED PRODUCT FEATURES
SAFESENSE
®
TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1
2
Press Auto-On (I)
Touch test area and
look for the SafeSense
indicator to illuminate
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
A
A
B
PAPER JAM
1
2
Set to Reverse (R)
Alternate slowly back and forth
All manuals and user guides at all-guides.com
2
3
Press Auto-On ( I )
Feed into paper
entry and release
3
SafeSense
is active and
®
®
working properly
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off (O)
A. Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum
operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will
not operate for the duration of the recovery time. See Basic Shredding Operation for more information
about the continuous operation and recovery time for this shredder.
B. SafeSense
®
Indicator: If hands are too close to the paper entry, the SafeSense
and the shredder will stop shredding.
3
4
Set to Off (O)
and unplug
4
5
OR
Hold card at edge
Feed into center of
entry and release
2
3
Set to Reverse (R)
* Apply oil
2-3 seconds
across entry
6
5
Pull uncut paper from
Set to Reverse (R)
paper entry
6
Set to Off (O)
®
indicator will illuminate
3
Publicité
