Publicité
Les langues disponibles
Les langues disponibles
hot water escaping from the filter holder. Ensure to release the pressure into water
tank before removing the filter holder. DANGER! There is risk of scalding.
• Release pressure through hot water/steam nozzle before removing filter holder.
• Warning: Avoid steam burn.
• When the steam function is used there can be some hot water dripping from the
brewing head. DANGER! The water is hot, there is a risk for scalding.
• When opening the steam knob there is a shot of hot water coming out. Be careful
and open the steam valve slowly. DANGER! The water is hot, there is a risk for
scalding.
• Do not immerse the appliance in water or any other liquid.
• Do not exceed the maximum filling volume as indicated on the appliances.
• Fill the water tank only with cold water, never with milk or other liquids.
• Always use fresh water to brew espresso to promise the best taste.
• Do not use the appliance if the water tank has not been filled.
• Do not use the appliance without the drip tray or drip grid, unless a higher cup/mug is
in use.
• Do not use or place the appliance on a hot surface or near source of heat.
• Warning: Avoid spillage on the connector.
• This appliance is intended for domestic use only. The manufacturer cannot accept any
liability for possible damage caused by improper or incorrect use.
• This appliance is not intended to be operated by means of an external timer or
separate remote-control system.
This appliance is intended to be used in household and similar applications such
as:
- staff kitchen areas in shops, offices and others working environments;
- farm houses;
- by clients in hotels, motels and other residential type environments;
- bed and breakfast type environments.
GETTING STARTED (picture page 3 and 4)
Start the machine for the first time
1
Place the machine on a flat surface. Plug in the machine to turn on its stand-by mode, while
turns half on. Fill the tank with cold pure water. Put filter cup into filter holder, and then fix it onto brew-
ing head anti-clockwise from "LOCK" to "CLOSE" position without coffee. Make sure the knob is at the
horizontal position ("OFF" position).
2
Start the machine with the
3
When buttons stop blinking, pre-heating is done. Press
may be noise when pumping the water for the first time. It is normal. The machine is releasing the air
from inside. The noise will stop after about 20 seconds.
4
When brewing is finished, remove the filter holder clockwise, clean up the filter and clear up the drip tray.
Now the machine is ready to use. NOTE: The machine will turn off automatically after 20 mins of no
operation.
www.aeg.com
button, whose light turns fully on and
and
buttons start blinking.
button to start brewing process. NOTE: There
GB
AR
BG
DE
ES
FR
GR
NL
PT
button
7
Publicité
