Publicité
GG
6. Attach the Crown Molding (FF) and Base (GG) by sliding the Rafix Bolts (JJ) into the Rafix
Cams (II). Tighten the Cams. See Figure 6.
To square the unit:
7. Place the unit face down on a clean, protective surface and measure from top left to
bottom right (1/2) and bottom left to top right (3/4). If the measurements are not equal,
tap on one of the corners until the amounts are the same. See Figure 7.
Using the pre-drilled holes as guides, fasten the Back Panel (EE) to the unit with #6 x 5/8"
Philtruss Screws (KK). Do not over-tighten the screws because that might cause you
to strip the wood.
Page 6 — 748Wc — 10/13
Fig. 6
Db
Fig. 7
KK
KK
Ab
FF
Cb
EE
x 6
KK x 18
Bb
Publicité
