Munchkin Shine Notice D'utilisation page 5

Contents | Contenido | Contenu
How to Use
FOR USE WITH ROOM-TEMPERATURE OR REFRIGERATED LIQUIDS
ONLY. FROZEN MILK OR FORMULA MUST BE THAWED BEFORE USING
THIS APPLIANCE.
NOTE: The warming modes on page 7 are to be used as a guide only. There are many
factors that can impact warming speed and final temperature, such as ambient temperature,
water temperature, formula/milk starting temperature, etc. Adjustments to these instructions
may be necessary. Always test temperature of bottle contents with a thermometer before
feeding baby. The ideal target temperature is 98
bottle contents should not be heated for an extended amount of time.
5. Press the control dial to turn the appliance on. Press it a
second time to begin the selected warming mode. The
warming cycle will begin and the control dial will pulse
gently to indicate that warming is in process.
NOTE: If the control dial is not pressed to begin the warming cycle within 5 seconds of
powering on the appliance, the preselected warming cycle will begin automatically.
WARMING TIMES
Warming
Mode
Estimated
2.5 minutes
Warming Time
NOTE: It is possible to switch to a different mode after warming has already started.
Simply turn the control dial to select the new mode and the appliance will override the
current mode and adjust the warming time. (See "ADDITIONAL NOTES" section for
more information).
8
o F (37 o C), which is body temperature. The
(Fig. A).
(Fig. A)
4 minutes 4 minutes 9 minutes
To turn off the appliance at any time during the warming cycle,
press and hold the control dial for two seconds.
6. Once warming is complete, the unit will beep three
times. Remove the lift-out basket from the warming
chamber immediately. Place the basket
(Fig. B).
onto a flat surface.
NOTE: After 15 seconds have passed, the unit will beep
five times as a final reminder that warming is complete
then turn off automatically. Do not leave the bottle in
the warming chamber after warming is complete—the
bottle may overheat.
7. While grasping the handle of the lift-out basket
with one hand, remove the bottle with your free
hand by lifting it upward until it passes through the
(Fig. C).
basket's rubber retaining tabs.
8. Gently shake the bottle and test the temperature of
the bottle's contents using a thermometer. This can
also be done by tasting the contents or by placing it
on the inside of your wrist to ensure that it is the
appropriate temperature for your baby. The ideal
o o
target temperature is 98 F (37 C), which is body
temperature. If the bottle is not warm enough,
leave it in the warming chamber slightly longer
next time. If the bottle is too warm, remove it sooner.
NOTE: The water in the warming chamber may stay hot
for a long time after the unit is turned off. Use caution
when emptying the chamber.
How to Use
(Fig. B)
(Fig. C)
9