Whirlpool FFT M11 82 EE R Guide Rapide page 3

Quick guide
CLEANING AND MAINTENANCE
THANK YOU FOR BUYING AN INDESIT PRODUCT.
In order to receive a more complete assistance,
WARNING: unplug the dryer during the cleaning and
please register your product on
maintenance procedures.
www.indesit.eu/register
Emptying the water tank after each cycle (see Fig. A).
PLEASE SCAN THE QR CODE ON YOUR APPLIANCE IN ORDER TO REACH MORE INFORMATION.
Pull the container out of the dryer and empty it into a sink or other
suitable drain, then place it back properly. Do not use the dryer
without having inserted the container back in place.
Cleaning the filters
Take out the filters and clean them by removing the lint from their
surfaces with your hand or a cloth or using a vacuum cleaner, then
put them back in place. The lint should be thrown in the garbage
bin and not washed through the drain in order to avoid spreading
microplastics in the used water system.
Do not use the dryer without having reinserted the filter in place.
Cleaning the door filter after each cycle (see Fig. B).
Remove the door filter as described below:
1. Open the door and pull the filter upwards.
2. Open the filter and remove the lint from all its parts. Replace
the filter correctly making sure it is fully seated.
Cleaning the bottom filter when the relevant indicator
turns on (see Fig. C).
NOTE: however, it is advisable to clean this filter after each cycle
to optimise drying performance.
Remove the bottom filter as described below:
C1. Open the bottom cover; take the handle and pull the filter out.
C2. Open the rear side of the filter and remove the lint from the
inner surface of the mesh.
C3/C4. Check the bottom filter chamber every month. If you
see residual lint accumulated on the metal fins, clean it with a
vacuum cleaner, using a nozzle with a brush.
It's crucial to do vertical movements, you may destroy the
component if you try to clean it in horizontal direction. Avoid the
direct contact of the hand with the fins - risk of cut.
C5. Close the rear side of the filter and place it back by checking it
is perfectly integrated into its seat, then lower the filter handle.
C6. Close the bottom cover.
Make sure the air intake is free.
The filters are essential parts for drying. They are intended
to collect the lint formed during the drying process. In case
of clogged filters, the air flow inside the dryer would be
seriously affected: the drying times would be longer, the
energy consumption would increase and the dryer could be
damaged. If these procedures are not carried out properly,
the dryer may not start.
NOTE: After cleaning the filters the relevant indicator remains on;
this is normal, it will disappear when you start a new drying cycle.
PRODUCT DESCRIPTION
Water Tank
1.
Air Intake
2.
Bottom filter
3.
Door filter
4.
Policies, standard documentation, ordering of spare parts and additional product information can be found by:
• Using QR code in your appliance
• Visiting our website docs.indesit.eu and parts-selfservice.europeanappliances.com
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When contacting our After-sales
Service, please state the codes provided on your product's identification plate.
1
4
2
3
Cleaning the tumble dryer
Before using the appliance carefully Before using the appliance carefully
• The external metal, plastic and rubber parts can be cleaned
read the Safety Instruction. read the Safety Instruction.
with a damp cloth.
• Clean the front air intake grille regularly (every 6 months) with
a vacuum cleaner to remove any lint, fluff or dust deposits.
Furthermore, remove any lint deposits from the filters area,
using a vacuum cleaner every so often.
• Do not use solvents or abrasives.
TRANSPORT AND HANDLING
Never lift the dryer by holding it at the worktop.
1. Unplug the dryer.
2. Remove the water from the water tank completely.
3. Make sure that door and water tank are properly closed.
4. If the drain hose is connected to your drainage system,
re-connect it to the back of the dryer (see "Installation" section
in the Safety Instruction guide).
Power consumption
off-mode (Po) - Watts
left-on mode (Pl) - Watts
Programs
Eco *
Eco
Synthetics
*This is the reference programme for the energy label and suitable to
dry normal wet cotton laundry. This is the most efficient programme
in terms of energy consumption for drying wet cotton laundry
(Standard/Default starting configuration).
A B
C
C1
C4
EN
0.42
2.00
Kg kWh Minutes
8 1.95 194
4 1.06 135
4 0.73 95
C2
C5
C3
C6