Publicité
Speed Control
The electronic speed controller (ESC) that comes with your model is a very powerful electronic
device.
Please follow these precautions carefully to prevent damage to the speed controller or other
components.
1. Battery operation: Always disconnect the rechargeable battery from the speed controller
(ESC) when it is not in use.
Driving your model
Before continuing, pay attention to the following important precautions.
1. Leave the model to cool down for a few minutes at regular intervals. This is especially
important when using battery packs with a high capacity that enable longer operating times.
Monitoring the temperature prolongs the lifespan of the batteries and the motor.
Operating the High-Low Transmission:
Use the "CH3/Channel 3" button on the remote control to switch between the 1st (slow) and 2nd (fast) gear. (Note the different speeds!) The gear lever and servo status indicates the
corresponding gear. (See fig.)
Operating the Transfer Case
1. CH4 / Channel 4 on remote control: Switches between the 3 driving modes.
> 4WD (all-wheel drive)
> FWD (front wheel drive)
> RWD (rear wheel drive)
> Choose a driving mode that is appropriate for the type of terrain.
4WD Transfer Case State
4WD Transfer Case Shifting Servo State
GB // 16
Low
Gear state
Low Gear Servo state (Low speed)
RWD Transfer Case State
RWD Transfer Case Shifting Servo State
2. Always adhere to the maximum and minimum limits of the speed controller as shown below.
Voltage range: LiPo cells: 2-4S ( 7.4-14.8V)
3. Switch on the remote control first: Switch on the remote control before turning on the speed
controller to prevent the model from moving unintentionally or in uncontrolled manner.
4. No reverse polarity protection: The ESC is not protected against reverse polarity. (Ensure that
it is connected with the correct polarity.)
2. Switching the gears:
1st gear: For maximum torque, drive the vehicle primarily in the lower gear.
2nd gear: The higher gear can be used for faster speeds. Only use this gear in open surroundings
with sufficient space. However, please note that continuous use can cause the motor/ESC to
overheat. This can lead to premature wear of the motor.
High Gear Servo state (High speed)
2. If a new servo is installed, please pay attention to the following diagrams. Configure the servo
parameters according to the status shown in the diagram. Ensure that no continuous force is
exerted on the servo, as this may cause damage to the servo.
High
Gear state
FWD Transfer Case State
FWD Transfer Case Shifting Servo State
Publicité
