Belkin RT3200 Guide De L'utilisateur page 5

Setting Up: Basics
Where to find more help
In addition to this user guide, you can find help at Belkin.com/support/RT3200(documentation,
downloads, FAQs, technical support, live chat, forums)
Note—Licenses and notices for third party software used in this product may be viewed on
http://www.belkin.com/support/license/. Please contact
http://www.belkin.com/support/gplcodecenter/ for questions or GPL source code requests.
How to install your router
If you're setting up this router as a traditional router or as the parent node for EasyMesh Wi-Fi, follow
these steps
1. If replacing an existing router, disconnect that router first.
2. Plug in the router to a power source. Make sure the power switch is in the | (ON) position.
3. Connect your new router to your modem or modem-router.
Plug one end of the included ethernet
cable into the yellow Internet port on
your new router. If you have a modem,
plug the other end into the Ethernet
(LAN) port on the modem.
Note—Wait until the power light on the front panel of the router stops blinking and is solid
white before moving to Step 4.
4. Connect to the network name shown in the Quick Start Guide that came with your router. (You
can change the network name and password later.) Select the option to automatically connect
to this network in the future. If you need help connecting to the network, refer to your device
documentation.
Note—You will not have internet access until router setup is complete.
5. Enter http://myrouter.local in a web browser. Follow the on-screen instructions to complete
setup.
You also can enter the IP address 192.168.1.1 in a browser to start setup. If you are using a
modem-router (gateway), it might already be using the 192.168.1.X subnet, and you can try
the 10.0.1.1 instead.
A
Modem
B
Plug one end of the included ethernet
cable to the yellow Internet port on your
OR
new router. If you have a modem-router,
plug the other end into any available
port.
Modem-Router
5