Télécharger Imprimer la page

Samsung NV7B4550UAB Manuel D'installation Et D'utilisation page 67

Publicité

Les langues disponibles

Les langues disponibles

Before you start
Initial settings
When you power on the oven for the first time, the default time of "12:00" appears
on the display where the hour element ("12") blinks. Follow the steps below to set
the current time.
10 English
1. With the hour element blinking, turn the
value dial (right-sided dial) to set the
hour, and then press OK to move to the
minute element.
2. With the minute element blinking, turn
the value dial to set the minute, and then
press OK.
To change the current time after this initial
setting, hold down the
button for
3 seconds and follow the above steps.
New oven smell
Before using the oven for the first time, clean inside the oven to remove the new
oven smell.
1. Remove all accessories from inside the oven.
2. Run the oven with Convection 200 °C or Conventional 200 °C for an hour. This
will burn any remaining production substances in the oven.
3. When complete, turn off the oven.
NOTE
• At the first-time use, you may see some smoke inside the oven while it is
operating. However, this is not a product failure.
• As the temperature of the cooking room increases at an initial period, you may
find some spots on the inner glass of the door. If this is the case, turn off the
oven and wait until it cools down. Then, use kitchen paper or neutral detergent
with a clean cloth to wipe up the inner glass.
• It is also important to make sure that you operate the oven in a well-ventilating
kitchen environment.
Smart safety mechanism
If you open the door while the oven is operating, the oven light turns on and
both the fan and the heating elements stop operation. This is to prevent physical
injuries such as burns as well as to prevent unnecessary energy loss. When this
happens, simply close the door and the oven continues to operate normally
because this is not a system failure.

Publicité

loading