Kenmore Elite 79097502002 Manuel D'installation

30" Electric Range Installation Instructions
and liquids in the vicinity of this or any other appliance.
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. C
FOR YOUR SAFETY: Do net store or use gasoline or other flammable vapors
Canada
1. Clearances and Dimensions
a. Provide adequate clearances between the range and adjacent combustible surfaces.
b. Location——Check location where the range will be installed. Check for proper electrical supply and the stability of floor.
c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be
solid and level.
FRONT TYPICAL CABINET INSTALLATION 7 " SIDE
VIEW > VIEW
76,2cm
Minimamic 25cm 30" A | 33cm |
inimum to ' oe " ¢ 123")
wall on either 1? >| |< Minimum* 45,7em Minimum to
side of range
above 91,4cem
Cc 18" cabinets on = Maximum depth (
| either side for cabinets
(36") height. of range. above range top.
i t-— 63,5cm—>
i 25"
91,4em
36" *
Ce sem
|¢—30 1/37°— Ocm/0" Clearance below cooking top and
at rear of range.
FRONT 75,9em 65,4em
VIEW 29-7 /8" 25-3/4"
¢— 2 9 - 7 / #28
124,5cm
49"
Maximum
91,440,3cem
3641/8"
k ¥
ee
116,8 em s
46" 7o,dem
Door open \ aa 30 on
* 76,2 cm (30") minimum clearance between the top of the cooking
surface and the bottom of an unprotected wood or metal cabinet;
or 61 cm (24") minimum when bottom of wood or metal cabinet is
protected by not less than 0,64 cm (%") flame retardant millboard
covered with not less than no. 28 MSG sheet steel, 0,038 cm (0,015")
stainless steel, 0,067 cm (0,024") aluminum or 0,051 cm (0,020")
copper. The minimum clearance is 0 cm (0") for the rear of the
range. Follow all dimension requirements provided above to prevent
property damage, potential fire hazard, and incorrect countertop
and cabinet cuts.
Avoid locating cabinet storage space above the surface units to
eliminate the possibility of cabinets catching on fire, or personal
burns from reaching for the cabinets over the heated units. If cabinet
storage is to be provided, risk can be reduced by installing a range
hood that projects horizontally a minimum of 5" beyond the bottom of
the cabinets.
Important Notes to the Installer
1. Read all instructions contained in these installation instructions
before installing the appliance.
2. Remove all packing material before connecting the electrical
supply to the appliance.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
Printed in Canada
Ss se
S81
All dimensions for
be installed for the range
to be flush to the wall.
15,2 Cf
ie). Wall edge
important Note to the Consumer
Keep these instructions with your Use and Care
Guide for future reference.
318201733 (1202) Rev. C