sauermann Si-CPE320 Guide De Démarrage Rapide page 5

9. Set a channel
Channel configuration
Select Channels
Channel 1
Channel 2
Channel 3
Please connect the probe(s)
before configuring the channel(s)
Next
Connect a probe to The list of available
set a channel and tap
channel is displayed.
''Next''. Tap the required
channel.
10. Set an output
Select Analog output
Output 1
Output 2
Output 3
Tap the output to set
Activate the output
corresponding to the
previously configured
Set the output type and
channel.
high and low range
values then tap the back
arrow on the top left.
11. Maintenance
Please avoid any aggressive solvents. Please protect the transmitter and its probes from any cleaning
product containing formalin, that may be used for cleaning rooms or ducts.
12. Precautions for use
Please always use the device in accordance with its intended use and within parameters described in the
user manual in order not to compromise the protection ensured by the device.
Channel 2
PROBE 1 MODULE
Measure SELECT MEASURE
Units SELECT UNIT
Coefficient 1.000
Offset
Tap ''PROBE 1'' or
''MODULE''.
Parameters to set are
now available.
Analog
Output 2
4-20 mA Output 1 Output 3
Output Type
Output 2
100.0
High Range (%RH)
Output 3
0.0 Output 3
Low Range (%RH)
Tap ''Next'' to dis-
taping .
Channel 2
PROBE 1
PROBE 1 MODULE
Rel. Humidity
Measure
%RH
Units
1.000
Coefficient
0.00 0.00
Offset
Set the parameters
according to your
needs then tap the
back arrow on the top
left.
10:35 - 10/12/2021
27.7
Next
play measures.
Select Channel
Channel 1
Channel 2
Channel 3
Next
Channel two is confi-
gured. Tap next to
configure outputs.
Measurements
Channel 2 1
%RH