Publicité
Les langues disponibles
Les langues disponibles
10 STOVE PARAMETERS
Press SET to open and modify the main stove
parameters such as pellet load, flue gas extraction
speed, ambient air fan and ambient temperature
correction. Using the TEMP+ and TEMP- keys it is
possible to change the stove setting percentages
to correct its operation based on the pellets used.
Then press SET to confirm the modified parameter
and save it in the memory. Use the PROG+ and
PROG- keys to scroll the parameters. Press the
STOP key to exit the menu.
10.1 Loading Pellets
Allows all loading parameters to be increased or
decreased in percentage from 50 to +50%.
10.2 Fume Extraction
Allows all flue gas extraction parameters to be
increased or decreased in percentage from -50 to
+50%.
10.3 Room Fan
Allows all air ventilation parameters to be increased
or decreased in percentage from -50 to +50%. 16.4
Stand-By Function
Set parameter 100 to 1 to have the stand-by
function directly in the user menu. The stove will
therefore automatically go to stand-by mode if
the measured room temperature exceeds the
programmed temperature. The stove will restart
when the measured room temperature drops below
the programmed temperature.
11 LANGUAGE SELECTION
It is possible to select a language for the messages
on the display from Italian, English, French,
German, Spanish, Dutch. Other languages are
available on request. The selection is made by
using the PROG+ and PROG- keys.
12 LAST ERROR LOG
The menu allows you to view the last errors
recorded by the board accompanied by the date
and time of the event, as well as a brief description
of the event itself.
13 DUCTED
In this menu, if provided by the Hardware, it is
possible to manually change the external or
ducted fan from 0, off, to 5, maximum speed. In
any case, it will work if the fumes, and therefore
the stove, are at the temperature set by the fan
parameters.
20
13.1 Ducted left
In this menu, you can set the left motor ducting or
ventilation speed from 1 to 5, which allows you to
choose the heat propagation speed. If the value is
set to AUTO, the ventilation follows the set power
of the stove. If the AUTO function is not set, the
fan will be freed from the stove power, except
for when the flame switches to modulation mode
(when the stove reduces or increases its power
level).
13.2 Ducted right
In this menu, you can set the right motor ducting or
ventilation speed from 1 to 5, which allows you to
choose the heat propagation speed. If the value is
set to AUTO, the ventilation follows the set power
of the stove. If the AUTO function is not set, the
fan will be freed from the stove power, except
for when the flame switches to modulation mode
(when the stove reduces or increases its power
level).
REMOTE CONTROL (OPTIONAL)
CODE MEMORISATION
Press the PROG+ and TEMP+ keys for about
5 seconds, until the message "IR REMOTE
CONTROL" is displayed. Now point the remote
control toward the panel and press any of the keys
present. An acoustic signal will inform the user that
the operation was successful. Exit the menu using
the STOP key and try to control the stove.
08/2021 - EN
The system is designed for use with
the optional IR remote control, which
can be installed at any time. The
remote control allows the stove to be
turned on and off by remote. Before
use, the remote control code must be
memorised. This operation is carried
out directly from the stove panel
without the need for any other tools.
Publicité
