Levoit Dual 150 Serie Manuel D'utilisation page 11

Descaling Your Humidifier (cont.)
9.
Use the cleaning brush and a soft cloth to
remove scale from all parts.
10.
Rinse all parts until any vinegar smell is
completely gone. [Figure 3.14]
11.
Dry all parts with a cloth. Make sure all parts are
completely dry before reassembling or storing.
Figure 3.14
Reassembling
1.
Flip the water tank over and place the noise
silencer back into the tank. [Figure 3.15]
2.
Place the water filter assembly back into the
tank and rotate it clockwise to secure it in
place. [Figure 3.16]
Figure 3.15
Problem Possible Solution
Turn the mist level to a higher setting.
Fill the water tank.
There may be too much water in the base chamber. Empty the base chamber. Refill the water tank
(not the base chamber) and place the water tank properly onto the base.
Make sure the air inlet on the bottom of the base is not blocked. The humidifier should not be set on
carpet or other surfaces that may block the air inlet.
Little or no mist
Make sure the nozzle is not blocked or clogged.
comes out.
Make sure the humidifier is on a level surface.
The water temperature may be too low. Turn the mist level to the highest setting and let the
humidifier run for a while, then adjust to the desired setting.
If the water tank or base was washed with detergent, rinse thoroughly with clean water to remove
any detergent.
Clean the water filter assembly (see page 9) or replace it with a new one (see page 12).
Humidifier doesn't
Plug in the humidifier and turn it on.
turn on, or turns off
unexpectedly.
Add purified or distilled water to the water tank.
3.
4.
5.
Storing
Follow the cleaning instructions (see page 9) and
allow all parts to dry completely before storing.
Store in a cool, dry location.
Replacing the Filter Assembly
If the filter assembly is damaged or water
cannot flow into the base chamber, the filter
or filter assembly needs to be replaced. For
more information, contact
(see page 12).
Figure 3.16
Place the float back into the base chamber:
a.
Make sure the correct side of the float is
facing up. [Figure 3.17]
b.
Insert the smaller prong into the closed
side of the float brackets. [Figure 3.18]
c.
Place the larger prong into the open
(U-shaped) side of the float brackets.
Refill the tank, if necessary.
Place the tank properly on the base and place
the tank cover on the water tank.
Figure 3.17
Customer Support
EN
Figure 3.18
11