DeWalt DXDP500001 Manuel D'utilisation page 7

English
Single / Double Legged Tool Lanyard
WARNING:
Do not wrap lanyard around, or
across your neck.
WARNING:
Do not attach by looping or knotting
the lanyard.
NOTICE:
Prior to using this product, user must ensure
that the tool to be attached on the lanyard is tightly
taped with the appropriate connector.
Make sure you tape the
webbing connector on
the tool .
Attach the desired tool to
the lanyard loop.
Now attach the carabiner
of the tool lanyard to the
D-ring of the waist belt of
the harness.
Tool lanyard is ready for
use.
Not for use with power
tools.
10
Please follow the same instructions mentioned for the
single leg lanyard.
This tool lanyard has two ends, one end comes with pre-
installed carabiner and the other with a loop.
WARNING:
When using Retrofit Tool or
Anchor Attachments, the user must ensure that
the Maximum lanyard length identified on the
attachments is compatible with the identified
lanyard length indicated on the tool lanyard
label. Failure in doing so may not give optimum
utilization of the connection made.
WARNING:
When using tool lanyard and
accessories, basic precautions should always be
followed, including the following:
DOs
a ) The user must weigh the tool or tools to be tethered
to ensure they do not exceed the maximum safe
working capacity of the tool lanyard or any part of
your tethering system. User should also refer to the
label or user manual for information on maximum
capacity information.
b ) Always inspect tool lanyard and all parts of the
tethering system prior to, and after each use (refer to
inspection steps).
c ) Use extra caution around moving machinery or
parts, electrical hazards, chemical hazards or other
apparent hazards.
d ) Always wear appropriate personal protective
equipment when installing or using tethering systems.
e ) Always ensure the carabiners are closed and locked
properly.
English
f ) Always ensure the hook & loop closure fasten
properly.
g ) Make sure the lanyard carabiners are properly
attached and secure prior to use, and after each
transfer.
h ) Store this product away from tools and other
objects that could cause damage.
i ) Carabiner locks securely.
DON'Ts
a ) For tools weighing more than 5 lbs.(2.26 kg.), do not
tether such tool to the human body.
b ) Do not wrap tool lanyard around sharp or rough
edges.
c ) Never modify or alter tool lanyard.
d ) Never modify a tool or primary anchoring location.
e ) Never tie a knot in a tool lanyard.
f ) Never wrap the tool lanyard back to itself, unless
specifically instructed.
g ) Do not attach more than one Tool to each Lanyard (
or lanyard leg).
h ) Do not use this product if it interferes with the tool's
safe working condition, or the anchoring location -
including personal fall protection.
i ) Tool lanyard must not be used as hoisting tag-lines
or used to statically suspend tools and equipment.
j ) Never cinch the cord or carabiner around wrist.
11