Bianchi E-OLTRE Supplément Au Manuel page 9

INTEGRATED CARBON HANDLEBAR - ALUMINIUM STEM AND HANDLEBAR
SPRINT
I
ntegrated carbon handlebar
ALUMINIUM HANDLEBAR STEM AND BEND
The aluminium handlebar kits provided with the product, based on the chosen model, include the handlebar stem and bend designed
specifically for this frame.
3
4
The integrated handlebar is a component designed specifically for
the E-Oltre frame to offer optimum integration between frame, head
set and handlebar.
The E-Oltre frame uses the ICR head set system manufactured
by Acros to route the cables within the handlebar and frame. The
handlebar is designed to integrate seamlessly with the head set.
Handlebar assembly, maintenance and disassembly must be
carried out by a specialist retailer ONLY.
NEVER carry out work on the handlebar. These operations require
specific technical knowledge, tools and expertise and should ONLY
be carried out by a specialist retailer.
Adjusting the height of the handlebar to suit personal requirements
requires expertise, appropriate tools and practical ability. As such,
all adjustments should be carried out by a specialist retailer.
The handlebar stem is attached to the fork by two screws located
on the side of the handlebar and by a tapered nut; the screws are
M5x22 mm in length. The torque of the screws is 5-6 Nm.
K .1
It nr
During assembly, the cables will enter the handlebar bend near the levers and inside
the handlebar stem, and then enter the frame through the spacers and head set.
(Image 3)
K .2
It nr
During assembly, the cables will "run" externally along the handlebar bend (they will
not enter the handlebar bend near the levers) and will be partially covered under the
handlebar stem by a cover, and then enter the frame through the spacers and head
set. (Image 4)