Bianchi E-OLTRE Supplément Au Manuel page 3

EN
SPRINT
DECLARATION OF CONFORMITY
The manufacturer F.I.V.E. Bianchi S.p.A., located at Via delle Battaglie, 5 - 24047 Treviglio (BG), Italy, hereby declares that its products
conform with standards 2006/42/EC, 2014/30/EU, 2011/65/EU, 2014/53/EU, UNI EN 15194:2018 and ISO4210. The products also conform
with the provisions of Art. 50 of the Italian Highway Code (Italian Legislative Decree no. 285 of 30 April 1992, as amended, and as
amended by Art. 24/1 of Italian Law no. 14 of 3 February 2003), as defined by Art. 2, paragraph 1, letter (n) of the Agreement.
The complete list of product codes and the relative compliance information can be consulted under the "Declaration of Conformity"
link at https://www.bianchi.com/manuals/ .
GENERAL SAFETY WARNINGS
Please pay close attention to the following symbols.
Danger!
indicates a potential danger which may cause serious injury or death if not avoided.
Warning!
indicates practices and conduct to be adopted for safe product use.
Information!
Indicates additional information on how to use the product.
WARNING!
Please note that failure to comply with the warnings and provisions contained in this data sheet exempts the manufacturer of any
liability.
INFORMATION!
New and innovative components and features are being developed all the time. To check compatibility with drive units and/or group-
sets other than those originally installed on the Bianchi frame or to receive information and instructions on specific components that
may be required to install a product or upgrade one, please contact your preferred Bianchi retailer.
INFORMATION!
The technical details may have changed compared to the data and images found in this manual.
WARNING!
Read and keep this supplement and the bike user manual. Both contain important safety information.
INTENDED USE
ASTM CATEGORY 1
Racing, triathlon and time trial bikes, recreational bikes and city bikes including the e-Bike Pedelec versions.
Designed for use on paved surfaces such as asphalt roads and cycleways. The tires remain in constant contact with
the ground.