Pressalit MSCT 1 Manuel D'utilisation Et D'entretien page 24

Tilt function
The shower change trolley can be tilted approximately 3 degrees to allow the
water to drain when using the optional shower mattress.
The tilt function is controlled by the wired remote control unit.
en
It is still possible to raise and lower the unit when it is in tilted position.
Resetting
If the lifting function does not work properly or if the two lifting columns are out
of sync, try resetting the lifting system.
24
Press and hold the Tilt up button to tilt the unit. The
motion stops when the unit is tilted approx.
3 degrees, or when the tilt up button is released.
Press and hold the Tilt down button to level the unit. The
motion stops when the unit is level, or when the tilt down
button is released.
Press and hold the up button and the down button
simultaneously.
The columns will move down after a few seconds
while a beep tone is heard.
Keep holding both buttons until the beep tone
disappears .
The lifting columns are now reset.