Publicité
LAN connection: It is possible to combine Wifi and Ethernet connections,
allowing devices within the same site to be connected to the same LAN via
either cable or Wifi. In the event that the LAN loses connection to the Internet
but remains active locally, the devices may not be visible from the VOOL Portal,
but the load management function will continue to work as expected.
CAN connection: if only the LMC is connected to the Internet as shown in step
7.2.1, after disconnection none of the devices will be visible online. The LMC
however remains operational and manages the load management function
offline.
CAN connection: if all devices are connected to the Internet as shown in step
7.2.2, only the disconnected devices will lose online visibility. The LMC remains
operational and manages the load management function offline.
8.
Connect to the VOOL Network
The LMC can be connected online either via Ethernet cable, Wifi or 4G.
1.
Ethernet: Connect an Ethernet cable with Internet connectivity to
the Ethernet port on the LMC.
2.
Wifi: After powering up, wait for up to 2 minutes until the LMC creates
a Wifi hotspot named 'LMC ID123456789'. If the Wifi has already been
configured, the hotspot will not appear. To connect to the hotspot, enter
the password 'Vool1234' and configure the hotspot name and password.
In case the window does not appear automatically, open your browser,
enter a random domain address, and the LMC Wifi setup window will
open.
3.
4G: Your LMC comes with the hardware required for 4G connectivity. For
more details, contact support@vool.com.
Publicité
