Kohler K-3435 Guide D'installation page 3

Scrape off the old
wax seal.
1. Remove the Existing Toilet
CAUTION: Risk of hazardous gases. If the new toilet is not
installed immediately, temporarily place a rag in the closet
flange.
Turn off the water supply.
Flush the toilet.
Sponge out all remaining water from the tank.
Disconnect the supply shut-off valve, if present.
Remove the old toilet.
Remove the old wax seal from the floor with a putty knife.
Replace the old T-bolts with the new 5/16" diameter T-bolts.
Kohler Co.
Closet
Flange
3
T-Bolt
1021795-2-E