Husky H27LOCKER Guide D'utilisation Et D'entretien page 9

4
Align Side Locker to the Workbench
1. Place the Foam Block (CC) next to the Workbench.
2. Move and align the Side Locker (A) to the Workbench and seat it on the Foam Block (CC) to maintain balance. Then lock
the caster wheels.
Do not push the side locker at this time
CAUTION:
to prevent tipping. Lock the caster wheels on the
Workbench and Locker to prevent moving. Perform
this step on even oors to ensure alignment.
5
Attach Side Locker
1. On the inside of the Side Locker (A) use 6 pcs M6 Bolts (DD) and Washers (EE) to attach to the Workbench, Riser and Hutch.
2. Do not fully tighten until all 6 bolts are installed.
3. Align the Side Locker (A) to be ush with the edge of the Hutch and Workbench and then tighten all Bolts (DD).
4. After the Bolts (DD) are secured, the foam block (CC) can be removed.
EE
DD
CC
9 Please contact 1-888-HD-HUSKY
HUSKYTOOLS.COM
for further assistance.