Husky H27LOCKER Guide D'utilisation Et D'entretien page 6

Assembly
This Husky 27 in. Side Locker is only intended to be used with the Husky 61 in. 15-Dr. Heavy Duty Workbench (H61MWC15HP) AND
the Husky 61 in. Hutch and Riser (H61HUTCH). H61HUTCH must be installed onto H61MWC15HP prior to installation of H27LOCKER.
Model # H61MWC15HP SKU # 1005517358
Side Locker is designed to attach to either side of the Husky 61 in. 15-Drawer Heavy Duty Workbench.
- If mounting to the RIGHT side of the Workbench, then proceed to Step 1.
- If mounting to the LEFT side of the Workbench, then the door is in the correct position and skip to Step 2.
1
Installing Locker to right side of Workbench
1. Remove the door of the Locker (A) by removing the 11 Phillips head bolts inside the hinge of the Locker (A). Then re-install the
door with the 11 Phillips head bolts along the hinge located on the right side of the Locker (A).
Ensure the door is level and centered in the opening before tightening the 11 bolts.
Model # H61HUTCH SKU # 1005657708
Opening
Opening
direction
direction
A
6
Two people are recommended for assembly.
CAUTION:
A
Opening
direction