Husky H27LOCKER Guide D'utilisation Et D'entretien page 7

2. Remove the Power outlet (C) from the left wall of the Locker (A) by removing the 6 Phillips head screws from the outlet panel
cover (D) and gently pulling the Power outlet (C) and holder from the cabinet.
A
3. Remove from the H61MWC15HP Workbench, the side handle, bottle opener, rubber grommet, 2 power cord storage hooks,
power outlet and holder.
4. Remove the Power outlet from the H61MWC15 Workbench by removing the 6 Phillips head screws from the outlet
panel cover and gently pulling the Power outlet and the holder out of the cabinet. Be careful when pulling the cord through
the grommet to avoid pinching and damaging the cord. Once the cord plug head is pulled through, then remove the exterior
rubber grommet on the right side.
5. The right side of the workbench and hutch should be free of any obstructions to install the Locker (A).
6. If desired, the side handle can be relocated to the left side of the Workbench and the power outlet to the Locker (A).
D
C
7 Please contact 1-888-HD-HUSKY
Opening
direction
Remove
HUSKYTOOLS.COM
for further assistance.