ims PRO PROTIG 201 AC/DC Mode D'emploi page 21

Translation of the original instructions
RESETTING THE WELDING STATION
It is possible to restore the factory settings of the welding machine. When the station is in sleep mode, press the sleep exit push button for 3 seconds.
The station then displays "3", "2", "1" and then resets the unit.
DISPLAY OF SOFTWARE VERSIONS
When the machine is plugged into the mains, it displays the software versions of the power and the HMI boards.
HUMAN-MACHINE INTERFACE (HMI)
Up current
button
Pre-gas
button
Functions
Sleep Mode / Sleep Exit
Sub-processes
AC/DC
AC
- A/V display selection
- Hidden menu
JOB
PROTIG 201 AC/DC - 201L AC/DC
Sleep Mode /
Sleep Exit
Display
Pulse
Processes Trigger
Frequency Button
mode
Pictograms MMA TIG DC
•
•
•
•
Cold current Creating /
button
Recalling /
A/V display
Deleting JOBS
selection
Hidden menu
Downslope
Welding
current
Sub-processes
TIG AC
• • Button to put the product into and out of sleep mode.
In MMA process: access to "Pulse MMA"mode,
• •
In TIG DC: access the "Pulse" or "Spot " modes.
• • Choose between TIG "DC", TIG "AC" and TIG "AC - Easy".
Select the parameter to be adjusted between "Frequency",
•
"Balance" and "Electrode"
By default, the current setpoint is displayed on the HMI.
After welding (MMA and TIG DC), the value that is displayed
•
flashing is the welding current measurement. Pressing this
button button, the measured welding voltage is displayed.
Allows you to recall, create and delete a job. Refer to the
• •
JOB section for more information.
TIG AC
Post gas
button
AC
AC / DC
Comments
EN
21