Uline H-2563 Mode D'emploi page 2

Figure 2
Figure 3
Figure 4
PAGE 2 OF 6
ASSEMBLY CONTINUED
5. Align the middle pre-drilled holes of tabletop boards
to the table top support (different angle). Attach 3⁄"
lag screws and washers using the power drill and
7/16" socket bit. (See Figure 2)
6. Place the three tabletop boards on the A-Frame
bases. Align the pre-drilled holes with the A-Frame
base. Loosely attach tabletop board slats to
A-Frame base with the 3⁄" lag screws and washers
using the power drill and 7/16" socket bit (will tighten
later in step 9). (See Figure 3)
7. Flip table upside down. Loosely fasten one long
tabletop support to the base.
8. Loosely fasten the support slightly off center to the
tabletop with two 3" deck screws. Repeat the steps
with the other long tabletop support and fasten it
opposite of the first tabletop support. (See Figure 4)
9. Flip right side up. Make sure the table is square and
tighten all lag and deck screws.
1-800-295-5510
uline.com
NOTE: H-6681 mounting hardware sold
separately. Two packs are recommended.
0424 IH-2563