Garland XTRIM 100 Manuel D'instructions page 30

English
Cut approximately 4 meters of nylon yarn.
Take the tips of the thread, fold it in half, then insert
it into the notch of the spool (2) and wrap the 2 tips
of the thread in the same direction each in their
corresponding lane.
3
3
Block the tip of each thread in the two grooves (3).
Reinsert the bobbin into its notch (4) and position the
tips of the thread in the thread outlet holes (5).
5
Tug each thread until each has released 12 cm.
1
4
Carefully put the lower cover on (1).
6.2.4. HOLDING THE CABLE EXTENSION
6.3. START UP
6.3.1. CHECK POINTS BEFORE STARTING
The voltage and current supply must comply with the
indications on the rating plate. Before starting to work,
always make sure that the appliance works correctly
2
and that your operation is safe.
Do not use this device if it is damaged or insufficiently
regulated.Only use this machine.
Only use this machine for the purposes for which it
was designed. Any other use may be dangerous for
the user, for the device, and for the people, animals
and objects surrounding it.
Check:
- The machine and locate loose and/or damaged
parts (screws, nuts, etc.).
- That the guard is properly attached to the machine.
- That the head is not damaged.
Tighten, repair or replace everything you need before
using the machine.
30/112