Publicité
Les langues disponibles
Les langues disponibles
Flushing cycles
Frost-free storage
Ordering accessories
Recycling
Warranty and support
Troubleshooting
11 Remove the used coffee pod or the thin descaling filter from the pod
holder.
1 Rinse the water reservoir and fill it with fresh water until the MAX
indication. Place the water reservoir back into the machine.
2 Press the CALC button to start the flushing cycle.The water flows
continuously for approximately 5 minutes.
3 Wait until the machine has completed the flushing cycle. The on/off
button flashes quickly and the CALC button flashes slowly.
4 Empty the bowl and place it back under the spout.
5 Repeat steps 1 to 4 twice to complete the flushing procedure. When the
last flushing cycle is complete, the machine switches off automatically.
If the coffee machine has already been used and therefore has been flushed
with water, it may only be used and stored in a frost-free place to prevent it
from becoming damaged.
To buy accessories or spare parts, visit www.philips.com/parts-and-
accessories or go to your Philips dealer. You can also contact the Philips
Consumer Care Center in your country (see the international warranty leaflet
for contact details).
- This symbol means that this product shall not be disposed of with normal
household waste (2012/19/EU).
- Follow your country's rules for the separate collection of electrical and
electronic products. Correct disposal helps prevent negative
consequences for the environment and human health.
If you need information or support, please visit www.philips.com/support or
read the international warranty leaflet.
This chapter summarizes the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the
English
27
Publicité
