LENCO LS-500OK Mode D'emploi page 7

Locate the anti-skating weight
You will find a anti-skating weight with small fishing line from the package, please follow below steps to locate the
anti-skating weight:
1. Slip the looped end of the fishing line over the anti-skating weight adjustment stub and into the 3
(the correct anti-skating force for the factory-fitted cartridge).
2. Pull the anti-skating weight slightly to let the tie of the fishing line move to the stub.
3. Lift the anti-skating weight over the anti-skating weight wire support. The anti-skating weight should now be
dangling in free space to the left of support.
The anti-skating force must be adjusted corresponding to the down force as follows:
Down force
5 - 10mN
10 - 15mN
15 - 20mN
20mN and bigger
Stereo System Connection
RCA Jacks
• The RCA Jacks of this unit are shared as both the Phone output jacks and the Line output jacks. They are
determined by the Phono/Line Switch.
• When used as a line output, the jacks output analog line-level signals and could be connected directly with a
pair of active speakers or the appropriate input of your stereo system. When used as a Phono output, they
should be connected to the phono pre-amplifier or the phono input of the stereo system.
• The Red plug connects with the Right channel and the White plug connects with the Left channel.
Groove in the stub
1 st from bearing rings
2 nd " " "
3rd " " "
4 th" " "
- 7 -
rd
groove