SOMFY Amy Scene Player io Notice page 13

Amy Scene Player io
3.6.Tips and advice on use
3.6.1.Questions about the product?
Observations
The selected Scene does not launch when a
Scene launch button on Amy Scene Player io is
pressed.
The selected Scene does not launch when a
Scene launch button on Amy Scene Player io is
pressed (No LED reaction in the front when
pressing a button AND in the back when pressing
the On/Off button).
The selected Scene does not launch when a
Scene launch button on Amy Scene Player io is
pressed but the LED lights up.
The selected Scene does not launch when a
Scene launch button on Amy Scene Player io is
pressed but the LED lights up, the control point
has been added to TaHoma application and the
scene launcher has been configured in the
application.
The motorised product does not react when the
indoor temperature rises (the scenes
programmed in TaHoma in the event of a
change in indoor temperature do not launch).
NOTICE
If the product still does not operate, contact a drive and home automation professional.
3.6.2.Replacing a broken or lost Somfy control point
To replace the last broken or lost control point, contact a home motorisation and automation professional.
4.TECHNICAL DATA
Frequency range and maximum power used: 868.700 MHz - 869.200 MHz e.r.p. <25 mW.
The environment in which the product is used might reduce the radio range. The use in the same floor as the controlled
products is recommended. Radio range in free field: .
Operating temperature: 0 °C (+32 °F) to +48 °C (+118.4 °F).
Power supply: 1 x type CR2032 battery, 3 V.
SOMFY ACTIVITES SA, 74300 CLUSES FRANCE hereby declares that the radio equipment covered by these
instructions is in compliance with the requirements of Radio Directive 2014/53/EU and the other essential
requirements of the applicable European Directives.
The full text of the EU declaration of conformity is available at www.somfy.com/ce.
©
Copyright 2024 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
Amy Scene Player io is switched off,
the front panel buttons (Scene
launch 1, Stop/my, Scene launch 2)
are deactivated.
The control point battery is low.
Amy Scene Player io has not been
added to TaHoma application or
the scene launcher has not been
configured in the application.
External radio equipment is
interfering with the radio reception.
The temperature feedback to
TaHoma is deactivated on Amy
Scene Player io.
Solutions
Switch it on to activate the buttons
(refer to Switching on Amy Scene
Player io).
Change control point battery as
required (refer to Replacing the
battery).
Refer to Adding/Deleting Amy
Scene Player io.
Turn off any nearby radio
equipment.
Check sensor status on TaHoma
application and refer to Use with
TaHoma if necessary.
EN
13