SOMFY Amy Scene Player io Notice page 10

EN
1] Take the circular back cover and clip the Amy Scene Player io module onto it,
following the orientation indicated inside the circular back cover. Press firmly
on the front of the module, on the right and left near the my button as close
as possible to the translucent circle without pressing on the edges of the
module (to avoid unwanted radio transmission), until it clicks into place.
2] Amy Scene Player io can therefore be used as a remote control that can be
put down and moved around.
2.7.Tips and advice on installation
2.7.1.Questions about the product?
Observations
The selected Scene does not launch when a
Scene launch button on Amy Scene Player io is
pressed.
The selected Scene does not launch when a
Scene launch button on Amy Scene Player io is
pressed (No LED reaction in the front when
pressing a button AND in the back when pressing
the On/Off button).
The selected Scene does not launch when a
Scene launch button on Amy Scene Player io is
pressed but the LED lights up.
The selected Scene does not launch when a
Scene launch button on Amy Scene Player io is
pressed but the LED lights up, the control point
has been added to TaHoma application and the
scene launcher has been configured in the
application.
The motorised product does not react when the
indoor temperature rises (the scenes
programmed in TaHoma in the event of a
change in indoor temperature do not launch).
3.USE AND MAINTENANCE
CAUTION
To prevent damage to the product:
• Avoid impacts!
• Do not drop it!
• Do not spill liquid on the product or immerse it in liquid.
• Do not use abrasive products or solvents to clean the product.
NOTICE
To use the Scene launch 1, Stop/my or Scene launch 2 buttons, they must be activated: the product must be switched
on (refer to Switching on Amy Scene Player io).
10
Possible causes
Amy Scene Player io is switched off,
the front panel buttons (Scene
launch 1, Stop/my, Scene launch 2)
are deactivated.
The control point battery is low.
Amy Scene Player io has not been
added to TaHoma application or
the scene launcher has not been
configured in the application.
External radio equipment is
interfering with the radio reception.
The temperature feedback to
TaHoma is deactivated on Amy
Scene Player io.
Copyright
Solutions
Switch it on to activate the buttons
(refer to Switching on Amy Scene
Player io).
Change control point battery as
required (refer to Replacing the
battery).
Refer to Adding/Deleting Amy
Scene Player io.
Turn off any nearby radio
equipment.
Check sensor status on TaHoma
application and refer to Use with
TaHoma if necessary.
©
2024 SOMFY ACTIVITES SA. All rights reserved.
Amy Scene Player io