SOMFY Amy Scene Player io Notice page 11

Les langues disponibles

Amy Scene Player io

3.1.Scene launch buttons

NOTICE

To use these buttons, Amy Scene Player io must first have been added to TaHoma application and the scene launcher

configured in the application (refer to Adding/Deleting Amy Scene Player io).

▪ Press the Scene launch button 1 to launch Scene 1 configured in TaHoma

application.

▪ Press the Scene launch button 2 to launch Scene 2 configured in TaHoma

application.

The feedback LED flashes green during activation of the motorised product(s).

3.2.Stop/my button

Briefly press my to stop the last scene launched.

3.3.Checking the battery level

When the battery level is low, the feedback LED on the front of Amy Scene Player io

dims progressively during activation of the motorised product(s). When the battery is

too weak, the control point can no longer transmit radio orders, its operation is

inhibited.

Battery status can be checked on TaHoma application, if Amy Scene Player io has been added in TaHoma, and an alert may

be sent out if this feature is activated (Follow the instructions in TaHoma application).

3.4.Use of the temperature sensor

A temperature sensor, not visible, is embedded into Amy Scene Player io.

This sensor works in combination with TaHoma where it appears as an indoor temperature sensor.

When Amy Scene Player io is added in TaHoma application and the temperature feedback to TaHoma is activated on Amy

Scene Player io, the sensor measures the temperature inside the room (around Amy Scene Player io) and sends the

measured values to TaHoma. These temperature values can be consulted in TaHoma and can then be used for scenes to

optimize home automation.

CAUTION

Be careful in case of wind!

Automation provided by TaHoma and Amy Scene Player io allows the automatic use of a motorised product when the

temperature of the room equals a certain threshold, without consideration of the wind.

To maximize the protection of the motorised product from the wind and limit the risk of breaking, use a wind sensor

paired with the motorised product (sold separately).

In any case, a wind sensor does not protect against sudden gusts of wind. In the event of such weather risks,

deactivate the embedded temperature sensor (see below).

3.4.1.Adding Amy Scene Player io in TaHoma

Amy Scene Player io should already be added to TaHoma, refer to Adding/Deleting Amy Scene Player io in TaHoma in

the Installation section.