Publicité
Tips on creating a strong password:
A valid password range must be between
8 and 16 characters. You can use a
combination of numbers, lower and upper
case letters, and special characters : _ - , .
* & @ / $ ? Space. The password must
contain characters from at least two of
these groups.
The password is case-sensitive so use a
mixture of upper and lower case letters.
The password must have between 8 and
16 characters.
Do not use personal information or
common words as a password.
Figure 5: Password activation window
User Name: It is always
"admin". It cannot be
changed.
Enter the new admin password and confirm it.
Express installation
The recorder has an express installation
wizard that lets you easily configure basic
recorder settings when first used. It configures
all cameras simultaneously. The configuration
can then be customized as required.
By default, the setup wizard will start once the
recorder has loaded. The wizard walks you
through some of the more important settings
of your recorder. Select the preferred
language for the system and then set the
administrator password. There is no default
password provided.
The wizard will then guide you through the
menus to set the time and date, network
configuration, HDD management, and
recording configuration.
6
The bar showing
password strength
When all the required changes have been
entered, click
Finish
recorder is now ready to use. Recording starts
automatically.
Note: If you should forget your admin
password, please contact Technical Support
to reactivate the unit with a new password.
Operating the recorder
There are several ways to control the unit:
•
Front panel control
•
IR remote control
•
Mouse control
•
Web browser control
•
TVK-800 keypad
•
Software (TruVision Navigator, TVRMobile)
Front panel
The buttons on the front panel control fewer
functions than using a mouse. See Figure 3
on page 3 for the locations of the controls.
IR remote control
The IR remote control buttons are similar to
those on the front panel. Place the two AAA
batteries in the remote control.
The remote control is only included for the US.
For EMEA: You can purchase a remote
control by ordering part number TVR-
REMOTE-1.
To connect the remote control to the
recorder:
Menu
1. Press
on the front panel or right-click
the mouse and select Menu. The main
menu screen appears.
2. Select
Display Mode Settings
3. Check the recorder's device address value.
The default value is 255. The device
address is valid for all IR controls.
4. On the remote control press the
button.
5. Enter the device address value. It must be
the same as that on the recorder.
to exit the wizard. The
> Monitor.
Device
TVR 46 Quick Start Guide
Publicité
