Publicité
Les langues disponibles
Les langues disponibles
STORAGE
1. Deflate the airbed following the 'deflation' instructions.
2. Make sure the airbed is clean and dry.
3. Lay bed flat with sleeping surface facing upwards. Fold the airbed loosely and
avoid sharp bends, corners and creases which can damage the airbed.
4. Store the air bed in cool and dry location.
CLEANING AND MAINTENANCE
WARNING: Always turn the appliance OFF and unplug the power cord
from the electrical outlet before handling or cleaning it.
CAUTION: Do not allow water or other liquids to run into the interior of
the air pump, as this could create a fire and/or electrical hazard.
CAUTION: Do not use any abrasive cleaners or solvents, as this will dam-
age the air bed.
•
Do not attempt to clean the appliance in any other way than that detailed by
the manufacturer.
•
Clean the exterior surface of the appliance by wiping it with a soft, damp cloth.
Dry the appliance with a soft, clean cloth.
•
Clean the vents and openings of the appliance regularly with a vacuum
cleaner, using the brush attachment to avoid any dust build-up.
•
To store your product, we recommend using the original or a similar-sized box.
•
Store the appliance in a safe, clean and dry place, away from direct sunlight
and out of reach of children when not in use.
•
To extend the lifespan of the filter, a vacuum cleaner, using the brush
attachment can be used to remove dust from the surface of the filter.
IMPORTANT ADVICE
The ambient temperatures of air have an effect on the air bed internal pressure. At
low ambient temperatures the air will contract within the air bed and the air bed
will feel softer: add air as necessary. At high ambient temperatures the air within the
air bed will expand significantly and the air bed will become hard and may burst:
release air to avoid damage to the air bed or to soften the feel. Do not expose the
air bed to extreme temperatures.
Air inside of air bed may expand and contract with varying temperatures leading to
reduced pressure inside of air bed. If this occurs, simply add more air issuing the
pump to achieve desired firmness.
10 of 36 | English
Publicité
