Publicité
Les langues disponibles
Les langues disponibles
CLEANING THE GREASE FILTER
Note:
The grease filter must be cleaned when the display shows F (after 220 hours of operation).
1. Open the cover of the appliance.
2. Push the latch (A).
3. Support the grease filter (B) and remove it from the appliance.
4. Clean the grease filter. Use hot water and a mild cleaning agent.
5. If necessary, clean the grease filter in a dishwasher. Use a program with a low temperature.
Note:
The grease filter can change color after cleaning. This is normal.
6. Make sure that the grease filter is dry before installing.
REPLACING THE CARBON FILTER (OPTIONAL)
Note:
The grease filter must be replaced when the display shows C (after 100 hours of operation) or every 4
months.
Note:
This procedure is only valid if you installed the carbon filter with your appliance.
1. Open the cover of the appliance.
2. Remove the grease filter.
3. Replace the carbon filter (A).
4. Install the grease filter.
REPLACING THE LAMP
Note:
This appliance is equipped with LED light strips. They can be used for a long time. In case a LED light
strip is blown, it must be replaced by a qualified person to avvoid any hazard. Contact the Inventum
service department.
RESETTING A SATURATION INDICATOR
The control of the appliance shows an indicator on the display for certain cleaning and replacing intervals.
1. Make sure that the appliance is switched off.
2. Touch the timer button for a few seconds to reset a saturation indicator.
GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table.
2. If you cannot find a solution for the problem, contact the Inventum-servicedienst.
(Figure 9)
(Figure 10)
33
•
English
Publicité
