LG LF26C6360 Serie Manuel D'utilisation page 21

en-us_main.book.book Page 21 Wednesday, April 17, 2024 7:59 AM
2
Fit the hinge over the hinge lever latch
a
and slot it into place. Rotate the lever
clockwise and fasten the hinge.
3
Connect all the wire harnesses and the
ground wire.
4
Push the water supply lines into the hole on
the top case and pull them through the
backplate.
5
Hold the water supply connection and gently
push in the collet
d
supply lines as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tubes in
place.
b
c
to connect the water
NOTE
• Disassembling/Assembling the Water Lines
Collet Tube Insert line
e f g
• Gently press the collet and insert the tube until
only one line shows on the tube.
Assembling the Hinge Cover
Position the hinge cover in its place. Insert and
tighten the cover screws.
Connecting Refrigerator to
Water Supply
Before Beginning
These instructions assume you have an existing
water supply connection for the refrigerator. If
necessary, call a qualified plumber to install a
water supply line for the refrigerator.
• Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
• Do not install the icemaker tubing in areas
where the ambient temperatures fall below
freezing.
INSTALLATION 21
Clip
h