LG LF26C6360 Serie Manuel D'utilisation page 43

en-us_main.book.book Page 43 Wednesday, April 17, 2024 7:59 AM
• Installation and use MUST comply with all state
and local plumbing codes.
• Do not install if water pressure exceeds 120 psi
(827 kPa). If your water pressure exceeds 80 psi,
you must install a pressure limiting valve.
Contact a plumber if uncertain how to check
your water pressure.
• Do not install where water hammer conditions
may occur. If water hammer conditions exist you
must install a water hammer arrester. Contact a
plumbing professional if you are uncertain how
to check for this condition.
• Do not install on hot water supply lines. The
maximum operating water temperature of this
filter system is 100 ℉ (37.8 ℃).
• Protect filter from freezing. Drain filter when
temperatures drop below 40 ℉ (4.4 ℃).
• The disposable filter cartridge MUST be replaced
every 6 months, at the rated capacity or if a
noticeable reduction in flow rate occurs.
• To protect it from freezing, remove filter
cartridge when temperatures are expected to
drop below 33 ℉.
• Do not install systems in areas where ambient
temperatures may go above 110 ℉ (43.3 ℃).
• Where a backflow prevention device is installed
on a water system, a device for controlling
pressure due to thermal expansion must be
installed.
• Ensure all tubing and fittings are secure and free
from leaks.
Replacing the Water Filter (Type A)
• Replace the water filter:
- Approximately every six months.
- When the Water Filter indicator lights up.
- When the water dispenser output decreases.
• To purchase a replacement water filter:
- Visit your local dealer or distributor
- Search using "water filter" on lg.com
- Use replacement cartridge: LT1000P,
LT1000PC, LT1000PCS or ADQ747935**
1
Remove the door bin.
2
Remove the disposable water filter.
NOTE
• Replacing the water filter causes a small amount
of water (around 1 oz. or 25 cc) to drain.
• Wrap a cloth around the front end of the water
filter cover to collect any leaking water. Hold the
water filter upright, once it is removed, to
prevent any remaining water from spilling out of
the water filter.
3
Replace with a new water filter. Insert the new
filter into the filter head and rotate it
clockwise until the arrow on the new filter
lines up with the arrow on the filter head.
Swing the filter back into the compartment.
4
Replace the door bin.
5
After changing the filter, press and hold the
Water Filter button for three seconds to reset
the indicator light.
6
After the water filter is replaced, dispense 2.5
gallons of water (flush for approximately 5
minutes) to remove trapped air and
contaminants from the system.
NOTE
• Do not dispense the entire 2.5 gallon amount
continuously. Press and release the dispenser
pad for cycles of 30 seconds ON and 60 seconds
OFF.
MAINTENANCE 43