Casselin CBMS416V Mode D'emploi page 14

device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.
5.2 Use
WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
COMMISSIONING
The device must be completely removed from its packaging. All guards must be completely removed.
Place the unit upright on a sturdy, flat surface.
Never put the water bath on a flammable surface.
Do not install this device near open fires or other heating devices.
The electrical cable must be protected to at least 16 amps. The device must be plugged directly into a wall
outlet. Using a power strip will trip the device.
Clean and rinse the device before first use.
USE
Fill the tank with your sauce up to the Max level indicated inside the tank.
The sauce level must not be lower than the Min level. The appliance must not be used without sauce.
Connect the device, once connected, press the ON/OFF button.
Turn the temperature adjustment knob.
When the chosen temperature is reached, the red indicator light goes out.
When the temperature drops, the device starts to heat up again and the red light turns on again.
Never operate the appliance without sauce in the container.
REMARK
The appliance is equipped with a safety system in case of overheating. In the event of tripping, unplug the
appliance and allow it to cool. If this protection system activates regularly, it is essential to contact your
retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device. To do this, wait for the temperature to drop, press the Reset button.
EN