Domo DO1004BL Mode D'emploi page 32

CLEANING AND MAINTENANCE
· Do not place the appliance in the dishwasher.
· Remove the lid and clean with a damp cloth.
· Be careful when cleaning the blade.
· Fill the jug with warm water and a little bit of soap. Clean your appliance with the blend/
clean function (see the section on use). Clean the inside of the jug with a soft sponge. Do
not use a scouring pad as this will scratch the base.
· After cleaning, dry all parts thoroughly.
· Do not immerse the appliance in water.
PROBLEMS AND SOLUTIONS
Problem
The lights on the
display are off
The light of the chosen
setting is on, but the
appliance doesn't work
The appliance stops
working
You can hear several
beeps and the light of
the chosen program
blinks
The food is burned
32
DO1004BL
Causse
There is a problem with the
connection
There are too many
ingredients in the jug, the lid
is not in place
You didn't confirm the
setting with the start button
There is not enough liquid in
the jug
There is too much liquid in
the appliance
The overfill sensor is dirty
The jug wasn't filled
between the min and max
indication lines.
Solution
Check if the power cord is
properly connected
Remove some of the ingredients.
Ensure the lid is in place
Press the start button
The appliance has a boil dry
protection. The appliance will
shut down when there is not
enough liquid used
The appliance has sensor to make
sure it doesn't overflow. Pour
some of the liquid from the jug.
Clean the sensor with a damp
cloth
Ensure the base is always covered
with liquid, between the min and
max indication.