Publicité
Les langues disponibles
Les langues disponibles
B
Connecting to Wi-Fi via a wireless router with a WPS
Introduction
Configure Wi-Fi settings with the WPS (AOSS)
button on the wireless router.
To check if your wireless router is compatible
with WPS (Wi-Fi Protected Setup™), refer to the
operating instructions of your router.
Check that a LAN cable is not connected to the
unit beforehand. The wired and wireless
connection cannot be used at the same time.
8
US
1
Set the wireless LAN antenna,
then place the unit close to your
router.
See page
25
for how to set the wireless LAN
antenna of the unit.
button
(AOSS)
2
Set the NETWORK OFF/ON switch
to ON, then turn the unit on.
The NETWORK OFF/ON switch is on the rear of
the unit.
When the LINK indicator turns off, go to the next
step.
It takes about 1 minute to turn off.
Publicité
