Publicité
Les langues disponibles
Les langues disponibles
4. Retighten the shoulder blade screw while holding the
locknut with a wrench. nOTE: Nut should be tightened
to 260 lb-in.
Fig. E
14
13
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
WARNING: CUT OR AMPUTATION HAZARD.
Never have any part of your body near the cutters or
mechanism. Serious personal injury may occur.
Installing and Removing the Battery Pack
(Fig. F)
nOTE: For best results, make sure your battery pack is
fully charged.
Fig. F
7
8
To install the battery pack
7
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
8
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
14
12
into the tool handle, align the
Proper Hand Position (Fig. G)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the
main handle.
Fig. G
Cutting
WARNING: To reduce the risk of injury,
•
Do not cut short pieces of material that put
fingers near blades. Blade is sharp.
ALWAYS wear ANSI Z87.1 eye protection
•
(CAN/CSA Z94.3).
•
Blade is sharp. Keep hands away from
cutting edges and moving parts. Laceration
and amputation can occur.
WARNING: To reduce the risk of injury, always
store and transport the cutter with the blades
fully closed.
Before cutting, ensure the blade shoulder bolt and nut are
securely tightened. Refer to Figure E.
1. Push the directional button
and actuate the trigger switch
2. Insert the workpiece squarely between the fixed
blade
and the moving blade
1
directional button to the forward position.
CAUTION: Do not attempt to make angled cuts as it
will damage the workpiece and blade.
3. Ensure the workpiece is straight. Place the cable to be
cut against the fixed blade.
4. Pull the trigger until the workpiece is engaged by the
moving blade. nOTE: Workpiece may move slightly
during the cut.
5. When the cut is complete, release the trigger.
Cut Capacity
Copper cable
Aluminum cable
ACSR*
*does not cut Drake
English
5
to the reverse position
4
to open the blades.
and press the
2
750 MCM
1000 MCM
1590 MCM
9
Publicité
