Uebler i21 Notice De Montage Et D'utilisation page 16

Porte-vélos pour dispositif d'attelage
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
Fahrradträger_i21-i31.book Seite 14 Mittwoch, 19. April 2017 10:56 10
24
13
23
14. Push the holder (22) down. Slide the registration plate (23) into
the registration plate holder (13), push it upwards and then
insert it fully.
15. Let go of the holder (22) and check the registration plate
is secure.
Note
To insert registration plates that are taller, push the
stopper (24) to the rear and then slide the registration
plate fully into the registration plate holder (13).
Note
The registration plate on the cycle rack must match
the registration number on the vehicle and be clearly legible.
Detaching the cycle rack from the vehicle
8
21
III
I
9
1. Fold up the wheel rails (8) with the rear lights (9) on the left-
hand side (arrow I) using the bars (21).
2. Fold up the wheel rails (8) with the rear lights (9) on the right-
hand side (arrow II) using the bars (21).
Caution
Always close up the wheel rails (8) by the bars (21) and not by
the rear lights (9). The rear lights (9) may otherwise become
damaged.
22
M+P-25A-0207
6
7
1
21
II
8
M+P-25A-0208
3. Open the quick-acting clamp (7) upwards.
4. Fold down the rack's frame (6) (arrow III) and close the quick-
acting clamp (7) again fully so that the rack's frame (6) is
secure.
Note
Clean the quick-acting clamp (7) and rack's frame (6) with soap
water regularly if soiled or difficult to move.
IV
18
5. Remove the plug (12) from the socket (20) on the vehicle
and insert it into the plug holder on the wheel rail (8).
6. Open the cycle rack (1) using the key (5).
6
7. Push the bag (18)
onto the cycle rack (1).
8. Push the securing lever (11) and place the cycle rack (1)
upright (arrow IV).
9. Pull the cycle rack (1) down from the tow ball (19) towards
the rear.
10. Place the cycle rack (1) on the ground using the
receptacle (10), thereby closing the receptacle (10).
11. Close the cover of the bag (18)
12. Dismantle the installed holders (2), (3) and (4) in the reverse
order, see page 15 and store them in the side pocket of
6
the bag (18)
.
6. The bag is available as an optional extra (order no. 19840 for
Uebler i21 cycle rack, for cycle rack Uebler i31 order no. 19850).
- 14 -
11
10
19
20
12
5
11
8
1
M+P-25A-0223
6
.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

I3115900

Table des Matières