Light Bulbs - Uebler i21 Notice De Montage Et D'utilisation

Fahrradträger_i21-i31.book Seite 12 Mittwoch, 19. April 2017 10:56 10
Electricity supply
Uebler i21, for max. 2 bicycles
Uebler i31, for max. 3 bicycles
Maximum tube diameter of bicycle frame
Round tube
Oval tube

Light bulbs

14
17
Designation
3
14 Indicator
BL PY21W 12V yellow
3
15 Registration plate light
BL C5W 12V (1.4 inch (35 mm) long) white
3
16 Rear fog light for left rear light
BL PR21W 12V red
3
Reversing light for right rear light
BL P21W 12V white
3
17 Brake/rear light
BL P21/5W 12V white
3. Light bulbs are available from commercial retailers.
Mounting/detatchment of the cycle rack on
the vehicle
Caution
The towbar must be suitable for attachment of a cycle rack:
• D-value of tow ball (see "Technical data" on page 11)
• The towbar material must be at least St 52-3 (see type plate
on towbar)
If it is not, the cycle rack may become loose along with
the mounted bicycles, thereby injuring other persons or
causing accidents.
Clean and degrease the tow ball prior to mounting.
Caution
13-pole, 12 V
The change in vehicle dimensions (width, height, depth) when
13-pole, 12 V
driving with the cycle rack can lead to injuries to yourself and
other persons and/or damage to property if due caution is not
exercised.
Pay attention to the change in your vehicle's dimensions when
3 inch (75 mm)
entering driveways or passing through gaps. Extra caution is
3x2 inch
required when reversing.
(75x45 mm)
Caution
Check the lighting device is in perfect working order prior to
each journey, otherwise accidents may be caused.
Mounting the cycle rack on the vehicle
15
16
M+P-25A-0204
Spare parts
no.
E1687
E1687
E1687
E1687
E1687
1. Open the cover of the bag (18)
2. Push down the securing lever (11) so that the receptacle (10)
opens out.
3. Holding the cycle rack (1) vertically, push the receptacle (20)
onto the ball of the towbar (19).
4. Tilt the cycle rack (1) downwards until you hear the securing
lever (11) engage.
Ensure the red mark on the securing lever (11) is no longer
visible.
5. Check the cycle rack (1) is parallel to the bumper and is aligned
roughly parallel to the ground.
Check the cycle rack (1) is secure by shaking it back and forth.
If necessary, remove the cycle rack (1) and reinstall it.
4. The bag is available as an optional extra (order no. 19840 for
Uebler i21 cycle rack, for cycle rack Uebler i31 order no. 19850).
- 12 -
18
11
10
1
4
.
19
M+P-25A-0209