5. Close the housing cover.
6. Always check that the dust bag is correctly installed before switching on the vacuum
cleaner again.
Note: If the dust bag is fitted wrongly, the bag door may not close properly. Do not force the
door. Reinsert dust bag in correct position, push bag holder back in to place and close the
door.
Replacing the filter
Before you install a new filter, always switch off the vacuum cleaner and pull the plug out of
the socket. Your filter should be cleaned at least twice a year or when it becomes visibly solid.
1. Replacing the motor protection filter
– Open the housing cover.
– With no bag in the vacuum cleaner, take the filter out.
– Put a new filter.
Note: Always operate the cleaner with a filter installed. Reduced suction or motor damage
may be result of incorrect procedures.
2. Replacing air outlet filter
– Remove the grille by pressing down on the tabs until the grille is detached.
– Remove the outlet filter from its housing to clean it.
– Put the filter back in after it is clean.
– Put the grille back on, and seat it correctly by pressing on the tabs until you hear a click.
Note: Never use the vacuum cleaner without the air outlet filter.
Care and cleaning
1. Before you cleaning the vacuum cleaner always switch it off and pull the plug out of the
socket.
2. To prevent electric shock do not clean the vacuum cleaner with water and never allow the
vacuum cleaner to be in contact with water.
3. Use a damp or dry cloth to clean the vacuum cleaner. Only clean the housing and the
accessories.
Instructions for use
English
5