Publicité
Les langues disponibles
Les langues disponibles
Detergent and Rinse Aid ....
Detergent
Detergent specifically intended for use with dishwashers
must be used. The dispenser must be refilled before the
start of each wash cycle following the instructions provided
in the "Wash Cycle Table." The detergent dispenser is
located on the inside panel of the door.
Loading the detergent
To open lid "A", press button "B". The cleaning detergent
should be introduced into the two containers "C"and "D"
up to the rim.
After pouring in the detergent, replace the lid, pressing
down until it clicks.
Dishwasher detergent in tablets is now available on the
market, in which case you should place one tablet into
container "D" and replace the lid.
- To obtain the best results from each washing and dry-
ing cycle, powder detergent, rinse aid liquid and salt
should be used.
B
D
A
Notice: To facilitate closing the cover, remove any
excess detergent on the edges of the dispenser.
Warning
Three-in-one dishwasher tablets are now available on the market, and combine the detergent, salt and rinse aid all in
one. If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser
to prevent the formation of white streaks on your dishes or on the appliance interior.
Add rinse aid to the corresponding container only if you are dissatisfied with the results on your dishes.
In any case, please read the manufacturer's instructions provided on the packet.
If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain
number of cycles.
EN
All manuals and user guides at all-guides.com
C
14
Rinse Aid
This product makes dishes sparkle more as it improves
their drying. The rinse aid container is situated on the
inside of the appliance door; you should refill it when you
see the container is empty by means of indicator “D”.
(If your dishwasher is fitted with a “low rinse aid” indicator
light, fill the container up when the indicator light flashes
or lights up).
Loading the Rinse Aid
To open the dispenser, turn the "C" cap in the anti-
clockwise direction and then pour in the rinse aid, making
sure not to overfill. The amount of rinse aid used for each
cycle can be regulated by turning the "F" dose adjustor,
located beneath the "C" cap, with a screwdriver. There
are 6 different settings; the normal dosage setting is 4.
F
D
Important:
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs,
the dosage adjustor should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjustor
to a lower setting.
C
Publicité
