shark VACMOP RV2000WD Série Guide De L'utilisateur page 6

PREP YOUR HOME
Your robot uses an array of sensors to navigate around walls, furniture legs, and other obstacles while it
cleans. To prevent the robot from entering areas you don't want it to, set up no-go zones in the app. For
best results, prepare your home as indicated below, and schedule a daily cleaning to ensure all floor areas
are regularly maintained.
NOTE: Scheduling is one of numerous features that can only be done in the app.
OBSTRUCTIONS
Clear cords and small objects
less than 2.8" in height, and
open interior doors to ensure
a complete map of your
home.
THRESHOLDS
Your robot can climb over
most thresholds to get from
room to room, but if one is
too high, set up a no-go zone
in the app to block it off.
STAIRS
Your robot's cliff sensors will
prevent it from falling off
ledges. For the cliff sensors
to work properly in any
mode, all runners, rugs, or
carpets must be at least 16
inches from any stairs, or
must extend over the edge of
the stairs.
MANUAL CLEANING MODE
To manually start a cleaning cycle, press the Clean button on the robot or on the mobile app. To
immediately send the robot back to the dock, press the Dock button.
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your robot on a small
section of the floor to ensure there is no scratching.
s h a r kc l e a n . c o m
SCHEDULING
Schedule whole-home
cleanings with the app. To
schedule a mopping run with
the app, the reservoir must
be filled and installed in the
robot with the pad attached.
AVOID MOVING THE
ROBOT & DOCK
While your robot is cleaning,
do not pick it up and move it,
or move the charging dock—
this will impact the robot's
navigation and ability to
return to dock when cleaning
After setup is complete, follow instructions in the
is complete.
app to help your robot conduct an Explore Run to
create an initial map of your home.
The robot will travel from room to room to identify
REMOVE RUGS FROM
walls, furniture, and other obstacles as it cleans.
DOORWAYS WHEN
This run will take less time than a full cleaning, as it
MOPPING
doesn't cover the entire floor.
Before mopping, you must
set up Carpet Detection in
the app, and move any car-
pets or rugs that block access
to floors that you want your
robot to mop.
To vacuum, the fluid reservoir must NOT be
attached to the robot. Make sure the dust bin is
properly installed.
USING THE SHARK® AI ROBOT VACMOP™
IQ NAVIGATION™ AND AI LASER VISION
The robot's object detection technology helps it
navigate around obstacles taller than 2.8" in height.
Clear away small objects that may interfere with the
cleaning path of your robot.
Create no-go zones in the app to block off areas you
do not want the robot to enter. You can set up no-go
zones around small objects, or use them to block off
large areas.
VACUUM ONLY INSTRUCTIONS
NOTE: Be sure to charge the robot completely before
its first cleaning so that it can explore, map, and clean
as much of your home as possible. It may take up to 6
hours to fully charge your robot.
NOTE: Avoid moving the dock. If it is relocated, the
robot may not be able to find its way back to the dock.
If the robot is relocated while in use, it may not be able
to follow its intelligent cleaning path, or find its way
back to the dock.
s h a r kc l e a n . c o m