Cleaning The Wheels; Cleaning Side Brushes - shark VACMOP RV2000WD Série Guide De L'utilisateur

MAINTENANCE
CLEANING SENSORS AND CHARGING CONTACTS
CLEAN SENSORS AND CHARGING CONTACTS AS NEEDED. With a dry cloth, gently dust off the sensors
and contacts located on the bottom of the robot and on the dock.
IMPORTANT: The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.

CLEANING SIDE BRUSHES

CLEAN SIDE BRUSHES AS NEEDED.
NOTE: Remove and replace any side brushes that are bent or damaged. To remove a brush, lift it off its peg.
s h a r kc l e a n . c o m
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a dry cloth. To reinstall,
snap the brushes over the pegs. Spin the brushes
manually to make sure they are installed correctly.
MAINTENANCE

CLEANING THE WHEELS

CLEAN FRONT WHEEL PERIODICALLY.
See sharkaccessories.com for replacement parts.
Clean the wheel housing.
NOTE: Brush not included.
Periodically clean the drive wheels and the housing
around them. To clean, rotate each drive wheel
while dusting.
s h a r kc l e a n . c o m