Settings And Adjustments - Bellcome 1 Série Manuel D'utilisation

6.5.2 Settings and adjustments

You can change any standard settings of the terminal by the following procedures:
CALL SETTINGS:
Terminal in stand-by
1. RINGTONE
2. RINGING DURATION
3.RINGING VOLUME
(for both call from
the outdoor panel and
intercommunication)
6.5.3 Programming the terminal address
The terminals addresses are already programmed with address 1(ATA1), address 2 (ATA2) and
address 3 (ATA3), which is mandatory for the correct functioning of the system.
The programming is necessary if the addresses are changed by mistake during installation.
Any additional terminal connected in parallel must have the same address as the main terminal.
Step 1 Central unit SCU
Terminal
Step 2
ATA
Step 3
Central unit SCU
Any error during programming is signaled with [
Simultaneous long press of
The terminal goes in setting mode. You have 2 min. to
Step 1
set all the 3 features, in whatever order you choose.
We suggest the following sequence.
For setting the RINGTONE, short touches of
1 short touch of st
2 short touch of nd
Step 2
3 short touch of
rd
and so on up to all 5 ringtones available. The last played ringtone
remains set if
For setting the RINGING DURATION, short touches of
1 short touch of
st
with the selected ringtone.
2 short touch of nd
twice with the selected ringtone.
Step 3 3 short touch of rd
times with the selected ringtone.
4 short touch of th
ring for 1 min. with the selected ringtone.
The last configuration remains set if
again for 3 sec.
For setting the RINGING VOLUME, short touches of
Each volume level, from 1 to 7, is signaled with increased
intensity of the selected ringtone.
Step 4
The maximum level is signaled with 2 x [
next touch, the volume restarts from level 1.
The last configuration remains set if
again for 3 sec.
Touch to quit the setting mode. Or, it will automatically
Step 5
quit after 7 sec. since the last operation.
PROG
Long press of PROG.
Long press of
For terminal address 1 - 1 short touch of
For terminal address 2 - 2 short touches of
For terminal address 3 - 3 short touches of
PROG
Press PROG.
The terminal plays the 1st ringtone.
The terminal plays the 2nd ringtone.
The terminal plays the 3rd ringtone
is not touched again for 3 sec.
1 x [ ] = the terminal will ring once
BEEP
2 x [ ] = the terminal will ring BEEP
3 x [ ] = the terminal will ring 3 BEEP
1 x [ BEEEEP
The red LED turns on.
[ BEEEEP ]. The terminal goes in programming.
The red LED turns off.
]. The procedure must be repeated from Step 2.
BEEEEP
32
and [ BEEEEP ].
:
] = the terminal will
is not touched
BEEP ]. With the
is not touched
1 x [ BEEP ].
2 x [ BEEP
3 x [ BEEP
:
].
].