Bellcome 1 Série Manuel D'utilisation page 32

6.4.2 Programming the panel address
The panel is already programmed with address 1, which is mandatory for the correct
functioning of the system. The programming is necessary only if:
- The address 1 is changed by mistake during installation.
- Additional panels are installed. The system allows up to 3 additional panels (each with a SCU)
and each of them must be programmed from its own SCU with a different address – 2, 3 or 4.
Step 1 Central unit SCU
Outdoor panel
Step 2
APA
Step 3
Central unit SCU
Any error during programming is signaled with [
6.5. Use of the audio terminals (ATA)
(ringing volume setting)
The factory standard settings are the following:
Ringtone
Ringing duration
Ringing volume
PROG
Long press of PROG.
Long press of
Name 3
- For panel address 1 - 1 short touch of
Name 2
- For panel address 2 - 2 short touches of
Name 1
- For panel address 3 - 3 short touches of
- For panel address 4 - 4 short touches of
PROG
Press PROG.
Call answering
+ Audio Monitoring
(ringtone setting)
Talk volume + mute
Ding-dong (first in the list)
2 calls
Level 7 from 7
The red LED turns on.
[ BEEEEP ]. The panel goes in programming.
The red LED turns off.
]. The procedure must be repeated from Step 2.
BEEEEP
Access granting
(ringing duration setting)
AUX command
(auto gate, external lighting etc...)
30
1 x [ BEEP ] Step 3.
2 x [ BEEP ] Step 3.
3 x [ BEEP ] Step 3.
4 x [ BEEP ] Step 3.