Table des Matières
Publicité
ENGLISH
When the cassette is held with the recorded side upper-most and exposed tape facing the front,
the protective tab will be found on the left rear of the cassette.
All pre-recorded cassette are protected in this way to prevent accidental erasure of the
commercial recording. "Protected" cassette will prevent the record button from being operated.
If at any time you attempt to record and find that this button will not depress, never force the
mechanism or it may be damaged. Check that a cassette has been loaded and that tab has not
been removed. Recording on a cassette from which the tabs have been removed can be done
by covering the tab openings with a piece of adhesive tape.
CARE OF CASSETTE MECHANISM
Gently clean the tape head and pinch wheel/capstan assemblies after every 10 hours of using
the unit. A range of cassette care products are available.
The erase head and record/play head and the surface of the pinch roller are delicate and must
not be touched with metal objects such as screwdrivers. You may find it easier to clean the
assembly by pressing the PLAY button to bright head and pinch roller into view. Be sure to press
the STOP button after cleaning the mechanism.
Damage to the pinch wheel can occur if the unit is left in PLAY mode with the power switch off.
Under no circumstances should you attempt to lubricate any part of the machine.
USING THE CD/MP3
LOADING A DISC
1. Set the FUNCTION switch to CD/MP3/USB position.
2. Open the CD door. " OP " will be shown on the display.
3. Place an audio CD into the tray with the label side facing up.
4. Close the CD door.
The total number of tracks will appear on the display after several seconds.
5. To remove the CD, press to open CD compartment lid, grasp the CD by its edges, and
carefully take it out.
Note:
To ensure good system performance; wait until the disc tray completely reads the disc
before proceeding.
If no disc is loaded into the compartment, or the disc is placed upside down, the display will
show NO.
PLAYING A DISC
1. Press the PLAY/PAUSE/USB/SCAN button to start playback.
The playback starts from track 1, the "
To interrupt playback, press the PLAY/PAUSE/USB/SCAN button. The "
the current playing time will flash on the display.
To resume playback, press the PLAY/PAUSE/USB/SCAN button again.
2. To stop playback, press the STOP button, the total number of tracks appears on the display.
12
FOR SIDE "A"
ERASE TAB
" indicator is shown on the display.
7
CMP 574USB
" indicator and
Publicité
Table des Matières
