Table des Matières
Publicité
CMP 574USB
CASSETTE OPERATION
PLAYBACK OF CASSETTE
Be sure to tighten any slack tape in the cassette before use, using either a pencil or a ball-point
pen, simply insert the pen or pencil into the centre of spool and rotate to remove slackness.
Depress the STOP/EJECT button to open the cassette door.
Insert the cassette into the compartment with the open end facing upwards and the full reel on
the left hand side, push the cassette well down and close the door, be sure not to touch the tape
surface, Set the Function switch to "TAPE" position and press the cassette play button. To stop
playback, press the STOP/EJECT button once. To release the cassette, press the STOP/EJECT
button again.
AUTO STOP
When the tape reaches the end during playback or recording, the built-in auto stop system will
release the depressed play, record keys. The auto stop system operates while recording from
the built-in radio or CD player, only the cassette function is brought automatically to stop mode
and the radio or CD Player will continue to play.
RADIO RECORDING
A. Install blank cassette tape.
B. Set FUNCTION SWITCH to "RADIO" position. After selecting the desired band and tune the
TUNING KNOB to desired broadcast station. Then push down RECORD BUTTON and PLAY
BUTTON simultaneously.
C. After recording the desired broadcast, depress the STOP/EJECT BUTTON lightly, and then
set FUNCTION SWITCH to "TAPE" position in order to listen to the recorded broadcast.
D. Press REW button then play button to playback your recording.
ERASURE: When you record over previously recorded tape, the original recording is
automatically erased and replaced by the new recording.
CD/MP3 RECORDING
A. Install a blank tape into cassette compartment.
B. Set the FUNCTION switch to "CD/MP3/USB" position. Load a disc into the disc compartment,
start playback by pressing the PLAY/PAUSE/USB/SCAN button after the unit finished
reading the disc.
C. Depress the RECORD BUTTON and PLAY BUTTON simultaneously. Recording starts.
Press the STOP/EJECT BUTTON lightly to end recording, or the unit will stop recording
automatically while the tape reaches its end.
D. To listen to the recording, set the FUNCTION switch to select "TAPE" playing mode, then
start tape playback.
TYPES OF CASSETTE
Use only good quality cassettes (IEC TYPE 1) for making recordings. May be used to replay
other types of cassette but is unable to make proper recording on these more specialized tapes.
The use of C120 cassettes is NOT recommended in this machine.
PROTECTING RECORDING
Normally, anything recorded on the tape is automatically erased when new recording is made. It
is possible to protect your recording from accidental erasure by removing the tabs found on the
rear of the cassette.
6
ENGLISH
11
Publicité
Table des Matières
