Installation Instructions; General Installation Notes; Wiring - Furrion net-zero FSPP95SA-BL Manuel D'instructions

Installation Instructions

General Installation Notes

● Read through the entire installation section first before beginning installation.
● Be very careful when working with batteries. Wear eye protection. Have fresh water
available to wash and clean any skin contact with battery acid.
● Uses insulated tools and avoid placing metal objects near the batteries.
● Explosive battery gases may be present during charging. Be certain there is sufficient
ventilation to release the gases.
● Loose power connections and/or corroded wires may result in resistive connections
that melt wire insulation, burn surrounding materials, or even cause fire. Ensure tight
connections by using cable clamps to secure cables and prevent them from swaying in
mobile applications.
● Use with Gel, Sealed or Flooded batteries only.
● Battery connection may be wired to one battery or a bank of batteries. The following
instructions refer to a singular battery, but it is implied that the battery connection can be
made to either one battery or a group of batteries in a battery bank.
● Select the system cables according to 2.5mm

Wiring

A recommended connection order has been provided for maximum safety during installation.
The controller is a common positive ground controller.
Don't connect the loads with surge power exceeding the ratings of the controller.
For mobile applications, be sure to secure all wiring. Use cable clamps to prevent cables
from swaying when the vehicle is in motion. Unsecured cables create loose and resistive
connections which may lead to excessive heat and/or fire.
7
.
2
NOTE
NOTE
CAUTION
CAUTION